HIGH SPEED IMPACT vs. DITCHING.
GROK:
The debris evidence, particularly the right flaperon, does not support a single clean binary. Forensic configuration analysis and satellite kinematics favor a high-energy water impact with surfaces in the cruise position; fluid–structure modeling of the flaperon itself favors that the surface was still attached when it met the water, rather than having separated in flight and free-fallen.
### Flaperon damage pattern
The flaperon recovered on Réunion (confirmed as 9M-MRO) has fractured hinge fittings, localized leading-edge dents and cracks, and—most distinctively—loss of the trailing edge aft of the rear spar.
French DGA examinations (judicial technical assistance) and subsequent independent work concluded that this trailing-edge failure is the expected result of hydrodynamic loading while the flaperon was still mounted, not of an in-flight separation followed by free fall. The independent analyses (CAPTIO / Kamoulakos, published in 3AF and AIAA Aviation forum papers) adapt von Kármán wedge water-entry theory, validate the force histories with smoothed-particle hydrodynamics, and apply them to a finite-element model of the flaperon:
- Free-fall case: release near 5 000 ft at roughly 400 km/h yields a terminal water-entry speed of about 38 m/s at approximately 50° nose-down (center-of-gravity forward of the centroid produces a nose-down moment). Elastic and damage simulations under those conditions concentrate rupture at the leading edge—opposite to the dominant observed failure.
- Attached (“guided”) impact: lower-surface pressure is transmitted through the skins and trailing-edge honeycomb, producing tensile fracture and fastener “unzipping” immediately aft of the rear spar. That matches the recovered piece. The locus of horizontal speed, vertical speed and incidence that avoids trailing-edge rupture lies at combinations too low to be realistic flight conditions; essentially any attached water entry at flying speeds damages the trailing edge.
Thus the mathematics of the flaperon alone rules out simple free-fall of an already-detached surface more strongly than it distinguishes a gentle ditching from a steep, high-vertical-speed entry. Both can load the trailing edge if the surface is still on the wing.
### Configuration and end-of-flight kinematics
ATSB examination of the right outboard flap (and its relationship to the flaperon) found damage to the seal-pan stiffeners and rear-spar regions that aligns only when the auxiliary support track is fully inserted and the flaperon is near neutral. That is the retracted/cruise position. The possibility that the sequence began with flaps extended was judged much less likely. ATSB therefore stated that the aircraft “was not configured for a ditching.”
The final two SATCOM burst-frequency-offset values (00:19:29 Z and 00:19:37 Z) indicate a high and increasing rate of descent. Under plausible assumptions of track, ground speed and oscillator bias, derived rates are on the order of several thousand feet per minute rising to roughly 14 000–15 000 ft/min within the eight-second interval (other bounding assumptions give a still wider range). Boeing end-of-flight simulations that reproduce those BFO values place water impact within about 15 NM of the seventh arc, typically after an unstable post-flameout descent (phugoid or spiral) at high speed and high descent rate. A long, controlled glide or a prepared flaps-down ditching is inconsistent with both the BFO timing and the retracted high-lift devices.
Other recovered items (flap trailing-edge sections with similar rear-spar failures, tension fractures of attachments, and numerous small interior cabin pieces) further indicate substantial structural breakup rather than the large floating sections expected from a successful low-energy ditching.
### Combined conclusion
The flaperon damage is mathematically and simulation-consistent with hydrodynamic loading while the surface was still attached at water contact, and inconsistent with the leading-edge-dominated damage predicted for a free-falling detached flaperon at its estimated terminal state (~38 m/s, ~50° nose-down).
The same body of evidence—the retracted flap/flaperon position established by contact damage, the BFO-derived descent rates of many thousands of feet per minute, and the fragmented character of the debris—is inconsistent with a deliberate low-speed, flaps-extended ditching. The configuration and kinematics point to a high-energy impact (steep attitude, large vertical velocity) in the cruise configuration, with the flaperon remaining attached long enough for water loads to produce the observed trailing-edge rupture before the wing and airframe disintegrated.
No recovered debris set or published calculation uniquely quantifies the exact impact speed or attitude; the distinction that is supported is attached high-energy water entry versus either prior in-flight separation or a classic low-energy ditching.

Comments
Post a Comment
MH370 AND A.I. INPUT.